Adjusting Bikes Of Different Handlebars Type

It is not enough to just ride a bike without making sure that the position is angled in a way that is comfortable for the posture of the one riding it. People tend to get afraid of making adjustments on the bagger handlebars simply because they do not know the proper way of doing it. However, when done in a correct steps and procedure, this would give the comfort a rider is basically looking for. Below are the way on how this can be completed on easiest ways.

To start off, riders must know whether the current handlebars are threaded or thread less because these two has different means of adjusting procedures. For thread less types, begin with finding the spacers below and above the handlebar stem. If there are no spacers seen then most likely it is a threaded type.

Anyway, loosen up the screws at the back of handlebars. These screws are located on the back part and are often referred to as pinch bolts. An Allen wrench or a hex key that can fit on screws may be used to remove them all. Once everything are unscrewed, remove the top cap.

Insert neither wrench nor hex key into the bolt at the top then turn it, so that in a counterclockwise motion. Once that is successfully removed, it is time to have the spacers slide off then set it aside along with the bolts. Remove the handlebars off the bike then set it aside too.

Add more spacers on the stem of the bike to position it way higher than it was before. After adding enough of it and feeling like the height is enough to feel comfortable when riding, everything can be installed back to the bicycle like it normally was. Make sure to tighten the grip of all bolts to prevent unnecessary motions that may cause unbalancing when taking a ride.

If threaded type is the one that is owned then basically a rider has the longer stems that are fitted in the bike frame. This one has no spacers at all but has one bolt attached at the back part of it. On the other hand, it may also be a plastic ring that are attached on same back area.

First step with this one is measuring the length between the upper parts of stem to the exact bike frame. Be mindful of the exact measurement and take note of it if possible. This is in case there is a need of reverting it back to its normal height because the adjustment was not as comfortable as expected then this can be done easily.

Then proceed to loosening of the screw on top with still an Allen wrench. Do this in a counterclockwise motion about four to five times till it completely loosens up. Move it freely whether up or down depends on how high or low a person wants the handlebars should be.

Just make sure that when adjusting its height, it does not go beyond the marking that serves as guide on how high the handlebar should go. Raising it way beyond that would mean danger when riding the bicycle. Once the exact position desired is already achieved then go ahead and finish it through keeping it straight while tightening it on its top screw.